This receiver compitible with all Picooz or Furry micro copper transmitters. You can design your micro indoor airplane with this high quality receiver.

Features

Battery : 2 to 5 V (1 Cell LiPO or 2-4 Cell NiMh/NiCd)
Actuator Current: 25 mAh
ESC Current: 2Ah constant , 4Ah Max.
Channels: 1 Act. 1 ESC (Standart Mode) or 2 Act. 1 ESC (Expanded Mode with TRIM buttons)
Range: 15 Meter with standart Picooz IR Transmitter (Indoor Only)
Channel Resolutions: 14 level Trottle Channel,
±3 level Right/Left Channel,
20 level TRIM channel(Expanded mode only)
Control Bands: 3 Band selectable (A-B-C)

Setup Modes & Bands

Standard Mode (2 channels)

1 - Open and Select Band (A,B or C) from TX,
2 - Connect the battery on system,
3 - You will hear Short Beep (Arming) sound in 1 second
4 - Press "Left Trim" button when Beep
5 - You will hear One Long Beep for Standard Mode (1 ESC, 1 Actuator)
6 - After beep sounds system will record and run the Standard mode on selected band.

Expanded Mode (3 channels with TRIM buttons)

1 - Open and Select Band (A,B or C) from TX,
2 - Connect the battery on system,
3 - You will hear Short Beep (Arming) sound in 1 second
4 - Press "Right Trim" button when Beep
5 - You will hear Two Long Beep for Expanded Mode (1 ESC, 2 Actuator)
6 - After beep sounds system will record and run the Expanded mode on selected band.

Important Notice

This device sensitive to reverse polarity. Please double check the battery wires before power on.
Use good quality soldering iron with sharp tip for soldering.