Our shop is closed until 28 September 2018.
We are currently accepting orders but ship after the holiday,
Thanks for your patience...

STROBON v2 Navigation Light (RED)

New generation of our market leader Strobon Navigation Lights.
Now, it's configurable for 5 different patterns.
Strobe/Blink/Heartbeat/Rotating Beacon/Solid

More details

£4.49

This product is compatible with latest FAA and CAA anti collision lights rules for drones. It's visible from 3 miles away at night.



STROBON Lights are the most powerful navigation lights on the model market for years.

Now, it's configurable for 5 different patterns!

  1. Strobe  (Legendary Strobon v1 strobe effect. 3 fast flashes like xenon wing tip flash lights)
  2. Blink (Simulates belly or tail lights. Continuous ON/OFF)
  3. Heartbeat (standard beacon light pattern, ramp up/ramp down/off)
  4. Rotating Beacon (perfect simulation of rolling beacons. ramp up/flash/ramp down/off)
  5. Static (you can use it as landing headlights or static wing-tip lights)

It allows 2 different working modes;

  • RC Controlled Mode: Plug it on your RC receiver’s any channel for RC mode, then you can enable/disable it over selected servo channel. 
    Each Strobon counts the servo signals. So, you can plug more than one Strobon to the same RC channel to syncronize them.  (check the schematic below)

  • Standalone Mode: Power it with directly from the battery (3.5-6v) it works on Standalone mode and works continuously.


Strobon v2


Specifications 

  • Supply Voltage: 3.5 - 6 volt
  • Current Consumption per hour  @5V
    Strobe: 60mA (1A when flashing)
    Blink: 70mA (150ma ON)
    Heartbeat: 120mA
    Rolling Beacon : 170mA (1A when flashing)
    Static: 140mA
  • Diameter: 21.5mm
  • Height: 6mm
  • Screw Holes: 1.5mm diameter & 18mm distance
  • Weight: 1.50 gram without wires
  • Wire Length: 30cm (only for "with wire" option)


Accessories

We are strongly suggesting our specially designed polycarbonate lenses for this product. 
Please visit the lens page before checkout 

PATTERN SELECTION

All you need a piece of wire or a tweezer to change the pattern. 
Connect two small pads of the Strobon v2 board while it's working (it will not change the pattern when it's OFF)
It will stop working when you connect these pins and jump to next pattern when you release the connection. 
That's all.



Strobon v2 pattern settings

Airplane Navigation Light Locations

SCHEMATIC for SYNCRONIZED & RC CONTROLLED MODE

Strobon Connection Schematic

   

    RC CHANNEL SETTINGS

  

  

SCHEMATIC for STAND ALONE MODE
strobon light stand alone connection

Customer Video, Thank you Steven :)
on Tarot X6

  

Customer Video, Thank you Fernando :)
(you can find the instructions and wiring details under the video description)

  

Customer Video, Thank you Stan :)

Related Products