SimpleOSD X2

Latest version of legendary SimpleOSD.
Smaller, Lighter and much more flexible.

More details

Availability: In Stock

£23.75

Latest version of legendary SimpleOSD.

SimpleOSD X2 edition is the lightest OSD system on the planet (Only 1.95gr!!!.)

And the size is smaller than previous SimpleOSD versions.

 The concept of SimpleOSD is "flying like a bird without OSD scraps on the screen"

This is why SimpleOSD uses smallest fonts and has only 1 line OSD information on top with out default firmware.
By the way the hardware is open source. You can write your own code or upload other compatible OSD codes into the hardware with a standard FTDI Cable.

FTDI Connection

GPS and Current Sensor Installation

 

Features:

  • Working with both DIY-OSD(open source) and SimpleOSD XL(close code) firmwares. (compatible SimpleOSD XL firmware coming soon) 
  • 16Mhz Atmega328 Processor with Arduino Boot
  • Standard 6 Pin FTDI Port for PC connection and other Serial sensors as GPS
  • 100% compatible with DIY-OSD Project.
  • On-Board Voltage Sensor
  • One current sensor input
  • Simple  3 pin (video,+,-) connection to video system.
  • I2C pins ready to solder for all sensors.
  • 4 extra Analog input pin 
  • 6 extra Digital input pin 
  • 5V regulated output  for other sensors (120mA max)
  • Build-in LM1881 video signal seperator 
  • PAL & NTSC compatible
  • Only 1.95gr 

 

Documents:

 

Requirements:

Loading the DIY-OSD Firmware:

  • Run the Arduino Software
  • Open DIY OSD code (File>Open)
  • Select right com port from your computer (Tools>Serial Port)
  • Select right target device (Tools>Board>Arduino Pro or Pro Mini 5V,16Mhz with Atmega328)
  • Connect the FTDI cable to SimpleOSD X2
  • Press the load button of software and wait for done. 
  • That's all.



*If any problem about Arduino Software, you can follow their community forums.